[dwright1983]

Having a problem with my hurco bmc 50 running the ultimax 3. I have lost all power to the front of the machine. Yesterday the monitors started to get wavy lines through them and the machine would shut down and reset and try to start back up. This happend about 5 times before it shut down completely. I have power to the lights skimmers and fans in the back. No power to the controls or monitors. There is one fan that is not working and its the fan attached to the DC power supply. I replaced this fan with a new one and it is not working either. Curious if anyone has ran into this kind of issue and what i might try to fix it.

[gcude]

I have a BMC 20 and the monitor and console are, I believe powered from the 24V lead from the DC power supply in the left hand control cabinet on the back of the mill. Take a meter and check your DC voltages being output there. On my BMC 20, the 24V is the bottom lead.

[ies fixs]

dwright,

Sounds like an issue with your power supply. We're more than happy to evaluate it for you at no charge. shoot me an email and I'll give you my shipping information. [email protected]