Hi,

My 2. question in 2 days. Hope you do not mind!

I am looking for a solution to easily and hazzle-free insert tabs/bridges to simple 2.5D parts. Lets say I wanna cut a simple square out of a sheet of MDF . How to keep the square in place while routing - with thin tabs, right? Is there any built in tabbing in solidcam as for Vectrics Cut2D or a straight forward workaround/hack to achieve the same?

Also being challenging here: These tabs should be aligned to the 'bottom' of the part and only be a fraction as high as the part itself - not to just say very thin.

I'd very much appreciate your kind help on this one! Looking forward to hear from you.

Best, Hanns