586,061 active members*
4,497 visitors online*
Register for free
Login

Thread: Help with Hardinge program

Results 1 to 2 of 2
  1. 08-01-2014, 04:05 AM #1
    ajm100a
    ajm100a is offline Registered
    Join Date
    Mar 2008
    Posts
    31

    Help with Hardinge program

    I wrote a small program to loop on a Hardinge 42 with Fanuc O control. It works fine for say 45 to 60 minutes then stops in cycle without any alarms. Reset program and starts again fine till around hour later with same problem. Its like there is a parameter that limits loops to a set number. Here is the program ( written to exercise axis.)

    M03 S1000;
    G00 X253.0 Z290.0;
    G04 S5.0;
    M04 S1000;
    X50.0 Z50.0;
    G04 S5.0;
    M99;


    Any ideas???
    Reply With Quote Reply With Quote
  2. 08-01-2014, 04:07 AM #2
    ajm100a
    ajm100a is offline Registered
    Join Date
    Mar 2008
    Posts
    31

    Re: Help with Hardinge program

    Sorry, this should be in Lathes forum.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Do you need a program made for your mazak mill hire me for as low 50$ a program?
    By Lee337a in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 09-18-2014, 12:29 PM
  2. Hardinge Elite 27-Does opening main collet cause program reset?
    By Tolyatti in forum Hardinge Lathes
    Replies: 1
    Last Post: 04-15-2013, 09:04 PM
  3. Troubel looping a program in a 5 axis lathe program (sub spindle won't line up)
    By sul1 in forum G-Code Programing
    Replies: 4
    Last Post: 03-06-2013, 07:56 PM
  4. Outputting Common variable values into a program (with automated program number)
    By yaji63 in forum Fanuc
    Replies: 0
    Last Post: 12-27-2010, 09:55 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules