[awkward]

Hi guys
I am working at a company that has a Joemars HD50 CNC spark eroder. It is controlled by a Heidenhain controller.
Is it possible to programme it from NX8 and post to the sparker and if so does any one have a post prosesser.
Regards Stu.
:wave:

[Warek]

Hi
Did you found postprocessor for heidenhain?
I looking too

[awkward]

After talking around it appears that there isn't one as you cannot allow for the odd shapes of electrodes and then have the cam software detect collision and so write code that is appropriate for the job. I believe that the codeing is only done in MDI. :cheers:

[mycodes21]

Yes ,it does ,i can help you about post processor build.Please mail me,[email protected].

[nximran]

must have

[M.RISHIKESH]

Dear All

Good Morning

I am new to this forum so could not locate "New Thread"

We are having Heidenhain ND282B Id Nr. 344998-01, S.Nr. 20 584 302A G5 PGM 354 394-01, display is not getting ON and we found that Transformer on Power supply got open

Can any of you please let us have specification of Transformer as it is not available ??? or please guide me the right forum to ask this question.

Best Regards,

M. Rishikesh