If I plug in any one x y, or z axis and switching them around( x to x ,x to y , x to z) (y to x ,y to y , y to z) (z to x , z to y, z to z) I get a green light .
But if I plug in in more than one axis it faults right away
I have tried 12v – 24v and 48v power supplies and same thing happens
Have only the power supply terminals hooked up and a jumper from 10 to 12 and a green light when charge pump switch is off
I have holding torque on any axis when only one motor is plugged in, I power down and plug in another axis and it faults
Any suggestions what is happening?