I noticed that chart included the G15 & G16 codes. Anyone ever use those? I used to do those on a Fanuc OM. Does anyone know of they are only in a special Fanuc package/option group?
Programming in Polar is very handy. I used it all the time when I programmed Heidenhain controls. They do a good job on Polar.
G91 G16 G17
G1 X3. Y30 F10.
G15
This will feed from the current position, 3 inches at 30°.
It's easier than doing the trig.
Mike Mattera
Tips For Manufacturing Training CD's, DVD's for Mastercam, SolidWorks, Inventor, G-Code Training & More
http://www.tipsforcadcam.com