Dear all,
I have a Fanuc servo drive board
The Model is A16B-1200-0800 ?
If you can, please help me wiring required signal for this board (servo on, analog speed command, ..),
Or, if you have any document about it, please send me.
Thank all.
Dear all,
I have a Fanuc servo drive board
The Model is A16B-1200-0800 ?
If you can, please help me wiring required signal for this board (servo on, analog speed command, ..),
Or, if you have any document about it, please send me.
Thank all.
Nobody can help me?
these days I search in internet and have some information,
This boad is used in sevo amplifier A06B-6058-xxxx.
It have two connector tor CNIM and CNIL.
Each connector have 20 signal pins:
PWMA, COMA
PWMB, COMB
PWMC, COMC
PWDD, COMC
PWME, COMD
ISR, GDR,
ISM,GDM,
MCON, GND
DRDY
So, If you know what is the meaning of these signals,
and how can we connect these signal to use this board..
Please help me !
Thank all.
oscillogramm board A16B-1200-0800 ( pulse in input PWMA...PWMF)
Attachment 239748
how algoritm pulse (input PWMA....PWMF)?????
Three phase PWM (probably sinusoidal)
with high and low side signals
ISR and ISM are analog phase currents (+-4.4V) full scale
MCON is controller drive "on" signal to drive
DRDY is drive ready signal to controller
PWM inputs become outputs and report status if DRDY is not asserted