I use BobCAD with my protoTRAK 2 axis control and it works very well. My question is this. I am looking at maybe buying a DynaPath Delta 20 3 axis and I would like to post some text to the DynaPath to test it out. I do alot of decorative cutting on the protoTRAK, and would like to do the same with the DynaPath control. Is there anybody using BobCAD to post to a DynaPath 20? If so, what post are you using? I have downloaded all of the posts on the site, and I was going to start with the Delta 10 posts and go from there. But, if anybody has any insight as to which works the best I would appreciate it. Since I do not yet own the mill, I would like to narrow it down to the right post if I can. I don't want to waste alot of time fumbling around if I can help it. I am going to try and look at the mill again this weekend so if somebody is successfully posting to the Delta 20 control, please get in touch with me! Thanks!