I just bought a 1988 Denford Cyclone CNC Lathe, and it has no documentation. I also wanted to find an electrical schematic for it. My first challenge is to figure out how to wire it. I have 220V 3-phase power available. On the side of the machine it says 380V, and it has a transformer that has 380 on it. The controls appear to be in good condition, but the machine has been sitting idle for many years. It was originally in a vocational school with 440v 3-phase. This machine has a Fanuc OT-B and has lost all of its parameters. I would be willing to pay someone if they already have them loaded on a disk so that I may load them back into my machine. Any help would be greatly appreciated.

Thank you,
Bill Gillen