Hello group,
I found a nice piece of soft.
http://www.iisr-cnc.com/
one bad thing....nobody reply's...tel nr's are not anymore existing :stickpoke
have somebody info about this soft?
73's
Carl
Hello group,
I found a nice piece of soft.
http://www.iisr-cnc.com/
one bad thing....nobody reply's...tel nr's are not anymore existing :stickpoke
have somebody info about this soft?
73's
Carl
It could be that your calling in the middle of the night in Isreal. It could be shadey too, but why leave contact information? I suggest that you calculate the Time Zone and call during business hours of 9am-5pm. You may be supprised. I looks pretty good too.
Welcome to CNC Zone :cheers:
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
time zone...Israel is almost te same time Zone....CET...(i am form Belgium )
Originally Posted by on7nh
Ooops!!! Sorry I didn't see that.
:cheers:
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
Must be a HamOriginally Posted by on7nh
For a free simulator, have you tried MicroTech?
Al.
nope...www.microtech.com?
and yes.... Dah Dah Dah.....Dah Dit.... ect
Sorry, http://www.cncsimulator.com/info.shtml
Al.
Originally Posted by MaxHeadRoom
Have you tried this Simulator? I checked it out a few times but couldn't get through to the Suppliers. I had a couple of questions and they have not replied.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
Sorry I confused that one with this one http://www.cncezpro.com/
http://www.cncsimulator.com/info.shtml Is a bit on the primative side. No Pun intended
BTW: Have you tried this www.bobcad.com True 3D with Solid Modeling and G-Code. This is what I have been using since V17 2002. Upgraded to V19,V20 and now V21.
You can also try www.ncplot.com this is the best Back Plotter on the market today.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
I am using it at the moment, what was the questions?
I know it is not perfect, but its free
Oh, co-incidental post.
Al.