I'm going to start wiring my drive cabinet today and I was wondering if someone would look over my schematic and maybe point out any potential problems.
I'm using gecko 201's and Bob Cambells breakout board along with Mach2 software.
Since the breakout board doesn't connect to the disable pins on the geckos, should this be connected to spst switches are should I just not connect them at all.
The zipped file has a dwg and a dwf of the same drawing.
Any advice / commits?
Aspire, VCPro, PhotoVCarve, Cut3D, Mach3, Home built CnC.
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.