[yuso]

Hello all
Ref: Milling machine Bridgeport Eztrack series II CNC 3 axes.

Recently I change the Servo Amplifier of X axes ( Advanced Motion Controls)
To calibrate this axes ( after moving the 4 diferent resitor pot. in the amplifier card -loop gain-current limit.....) the manual of the Bridgeport, says that we need to run the FERROR program to do the calibration . This program is not in the Floppy that comes with the machine ( system operating backup files).
¿ Does any one have this program ? ¿ How to run it and calibrate the axes (speed).
Appreciate some help.
To send the program please use this Email: [email protected] or [email protected]
Thank
Yuso

[machintek]

Have you tried looking at other programs in the utilities section. I believe the following error set up program is a TXT file, not a conversational file. It is best to run it with PFM.exe. This is accessed with DOS. It can run a program with it in the tuner section and you can watch position error, DAC command, etc.

George

[yuso]

Thank George
I will try as your recomendation .

Thank for the help
Yuso