I need to get a breakout board and I don't know which to get. I previously wired direct from the parallel port to the stepper drives and used linuxCNC, I now want to use Mach3 and want spindle control using a VFD., I would like other outputs as well for accessories. All suggestions will be appreciated.
Thanks,
Tony
.
Thread: breakout board
Results 1 to 2 of 2
-
01-10-2017, 12:56 AM #1
Registered
- Join Date
- Aug 2010
- Posts
- 45
breakout board
-
01-10-2017, 02:32 AM #2
Registered
- Join Date
- Mar 2016
- Posts
- 8
Re: breakout board
I don't have a recommended breakout board for you, but I can unconditionally say that the C35 board is garbage, so stay well clear of that one. I got it working after countless hours researching wrong documentation and mis-information. The C6 board should work for spindle control - I'm not using a VFD but am using the 0-10volt control for speed which is the same as the VFD uses and it's nice.
Reply With QuoteSimilar Threads
-
Help deciding which breakout board or driver board etc to use!
By localbroadcast in forum Servo Motors / DrivesReplies: 7Last Post: 06-09-2016, 09:25 PM -
BREAKOUT BOARD INTERFACE BUFFER BOARD
By deslee in forum Servo Motors / DrivesReplies: 1Last Post: 08-17-2014, 07:32 PM -
Help with Breakout Board
By johnnyg in forum Stepper Motors / DrivesReplies: 19Last Post: 10-18-2012, 09:02 PM -
Which Breakout Board?
By gotfdirtball in forum Bridgeport / Hardinge MillsReplies: 7Last Post: 05-03-2011, 08:44 AM -
Breakout board, Relays on board?
By Cooper in forum Open Source Controller BoardsReplies: 11Last Post: 06-10-2007, 01:55 AM
Tags for this Thread
Posting Permissions
