I am interested what IC's this is using, anybody use anything like it?
http://www.bpesolutions.com/bpemanuals/dmxtoanalog1.pdf
Al
Results 1 to 2 of 2
Hybrid View
-
03-22-2005, 05:54 PM #1
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24220
Any R/C people using this circuit?
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
03-22-2005, 06:48 PM #2
Gold Member
- Join Date
- Jun 2003
- Posts
- 3312
The fact that he states 80mv steps would indicate D to A conversion. Could be an 8 pin micro and two D-A's running I2C serial bus. But its hard to tell.
PhilPhil, Still too many interests, too many projects, and not enough time!!!!!!!!
Vist my websites - http://pminmo.com & http://millpcbs.com
Reply With QuoteSimilar Threads
-
Looking for people wanting to develop new plans for a cheap cnc
By Hack in forum Open Source CNC Machine DesignsReplies: 308Last Post: 02-17-2010, 11:15 PM -
Gecko triggered E-stop circuit?
By sol in forum Gecko DrivesReplies: 20Last Post: 11-27-2006, 03:58 PM -
Electronic circuit copyright.
By ynneb in forum CNC Machine Related ElectronicsReplies: 5Last Post: 06-17-2004, 04:56 PM -
Something I was working on when 22
By Hobbiest in forum Community Club HouseReplies: 1Last Post: 03-13-2004, 02:27 PM -
Help w/ e-stop circuit design
By owhite in forum CNC Machine Related ElectronicsReplies: 4Last Post: 03-07-2004, 03:16 PM
Posting Permissions
