586,103 active members*
3,667 visitors online*
Register for free
Login

Thread: Help with MasterCam 4axis on FX10

Results 1 to 3 of 3
  1. 02-12-2010, 07:51 PM #1
    smilowski
    smilowski is offline Registered
    Join Date
    Feb 2010
    Posts
    0

    Help with MasterCam 4axis on FX10

    Help With 4 axis MasterCam And FX10
    can someone tell me why whenwe make a simple 4 axis program in mastercam with two 1 inch holes three inches apart at a 7.125 dree. angle. It looks good in mastercam but when we run it on the FX10 is turns out eggshaped.
    thanks justin
    Reply With Quote Reply With Quote
  2. 02-13-2010, 07:26 AM #2
    CNCRim
    CNCRim is offline Registered
    Join Date
    Feb 2006
    Posts
    992
    Hmmmm, It's hard to said it could be the program itself, it could be cutter comp not enough room for it to comp, it could be the ball bearing, but I have a feeling some with the program. Double check.
    The best way to learn is trial error.
    Reply With Quote Reply With Quote
  3. 02-15-2010, 10:00 AM #3
    Royster
    Royster is offline Registered
    Join Date
    Jan 2009
    Posts
    64
    Can you show me your NC code?

    Have you recently re-installed software and maybe not uploaded your pitch error/backlash info?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Help with 4 axis for FX10 wire Machine
    By smilowski in forum Mastercam
    Replies: 5
    Last Post: 05-16-2013, 03:23 PM
  2. Looking for an Epack for Mits. FX10
    By 3dmachinist in forum EDM Discussion General Topics
    Replies: 2
    Last Post: 08-25-2009, 12:23 PM
  3. SURFCAM 2004 POST FOR MITSUBISHI FX10
    By 3dmachinist in forum EDM Discussion General Topics
    Replies: 0
    Last Post: 08-19-2009, 11:24 PM
  4. mitsubishi fx10 alarms
    By waldocnc in forum EDM Discussion General Topics
    Replies: 0
    Last Post: 06-15-2009, 01:26 PM
  5. X4+ 4axis
    By Martin Long in forum Syil Products
    Replies: 3
    Last Post: 08-26-2008, 09:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules