For those of you that have water tables, what size did make them? Here's my dilemma... I have a 4x8 sheet of 1/8" steel and some 6"x 8' strips of 1/8" steel I could easily weld up a 4x8 water pan but then I wouldn't be able to cut past the edge of a 4x8 sheet of material. If I angle the sides out it makes mounting the slats that will support the work piece a bit more tricky. I could weld a 1" or 2" strip along the bottom edges to widen the 4x8 sheet by an inch or so but that's a long weld bead and it might warp the bottom plate. Am I over thinking this? Thoughts?
Thread: Water table size question
Results 1 to 2 of 2
Hybrid View
-
02-11-2010, 05:15 AM #1
Registered
- Join Date
- Nov 2003
- Posts
- 55
Water table size question
-
02-11-2010, 05:33 PM #2
Registered
- Join Date
- Jul 2008
- Posts
- 83
You've got it easy w/ a 4x8' table. Just buy a 5x10' sheet, cut to 5x9', notch the corners 5", bend the sides up and weld the corners.
Reply With QuoteSimilar Threads
-
Water Table Question !
By Pure-Powder in forum Waterjet General TopicsReplies: 3Last Post: 04-23-2008, 07:15 PM -
Water table question
By DRL in forum Waterjet General TopicsReplies: 2Last Post: 03-28-2008, 05:23 AM -
Water Table Question !
By Pure-Powder in forum Waterjet General TopicsReplies: 4Last Post: 03-07-2008, 03:09 AM -
Water Table Question
By DISCONNECTED in forum Waterjet General TopicsReplies: 5Last Post: 11-03-2007, 06:58 PM -
Water transfer techniques for water table?
By Knut in forum Waterjet General TopicsReplies: 3Last Post: 02-02-2007, 04:52 PM
Posting Permissions
