[spincaster]

I am trying to join four surfaces that were lofted. Three of the four can be joined but the fourth won't join.

What have I done wrong that prevents joining these surfaces?

Is there a way to get them to join?

File is too big to upload.

Assistance greatly appreicated!

Jack

[chmillman]

In general surfaces can't be joined because the edges are not within the tolerance specified in the file - that is to say they are not close enough to be joinable. There are many other possible problems, however, it is really difficult to diagnose without having the actual objects. You say the file is too big to upload - four surfaces are too big? Just export the 4 objects, check save small in the export box and zip the file afterward. --ch