[James Newton]

hey,
iv built d linistepper...
if u still around, could u please send me a pic of your entire circuit with break out board n drivers connected together with the psu.

Kinda stuck at that part..

The connections are documented here:
techref.massmind.org/techref/io/stepper/linistep/lini_use.htm

And there is a nice, clickable block diagram here:
techref.massmind.org/techref/io/stepper/linistep/4axis5build.htm that shows how it all goes together.

[rajshinai]

hey mr. james,
Checked the cost of the pcbs with the shipping and the customs charges, here in mumbai..totally, it makes it a lil expensive for me to ship it to india.

so guess, for a while im stuck to building them myself..built the sam waters version but cant figure out the connection for ground, for the power supply...
Been asking a lot of "electronic guys" around, but no help.
But learning a lot about electronics!

this is what iv made till now..forgive me my shabbiness..

[Sam Waters]

hey mr. james,
Checked the cost of the pcbs with the shipping and the customs charges, here in mumbai..totally, it makes it a lil expensive for me to ship it to india.

so guess, for a while im stuck to building them myself..built the sam waters version but cant figure out the connection for ground, for the power supply...
Been asking a lot of "electronic guys" around, but no help.
But learning a lot about electronics!

this is what iv made till now..forgive me my shabbiness..

Sorry I've havn't been around lately

Here are some more pics of my setup and a wiring diagram I put together.

The boards I drew up are designed to hook together at 90 deg angle to each other...

Hope the pics give you a better idea of how they go together.

[rajshinai]

Sorry I've havn't been around lately

Here are some more pics of my setup and a wiring diagram I put together.

The boards I drew up are designed to hook together at 90 deg angle to each other...

Hope the pics give you a better idea of how they go together.

Am really glad you replied...was finding it difficult to come up with a solution by myself...really helped.
Im using wires to connect the board to my driver..not tested them yet though.
And, wow that a real neat board uv built.

so are there any specific settings to set up the software ? (i was, actually giving up on running your version, till u replied)??

[Sam Waters]

Am really glad you replied...was finding it difficult to come up with a solution by myself...really helped.
Im using wires to connect the board to my driver..not tested them yet though.
And, wow that a real neat board uv built.

so are there any specific settings to set up the software ? (i was, actually giving up on running your version, till u replied)??

I'm using EMC2 on a mill, here are some screenshots of the settings.

[rajshinai]

I'm using EMC2 on a mill, here are some screenshots of the settings.

thank you, had set the pins using the schematic...but your screenshots helped me confirm them.


Now, it is time to order the belts! n calculate the ipm n ill be ready for world domination....MUHAHAHAHAHAhahahaa....!