[qwerty1000]

Hi guys!
It needs help! :drowning:
How to modify the postprocessor.
Now, if you clearly indicate the feedrate, the post focuses on the slowest axis. Thus, reducing the rate of displacement in the center of the details. I need that constant velocity was maintained in the center of the details, so that the velocity on the axes grew up as needed. 'll Show please.
My postprocessor:
http://www.bukvorez.ru/musor/mpwfanuc.zip

[Superman]

We also run a Fanuc wirecut (Robocut)
but we use the controls' pre-defined settings, the feedrates are not used in our programs

What machine do you have ?

[qwerty1000]

foam cutter
http://www.bukvorez.ru/blog/_su-27.htm

[weirdharold]

Question for you Superman since you mentioned Fanuc Robocut. We have 3 Fanuc Series 180 iS-WB EDM's. Great machines. Can you drip feed these wire EDM's via a memory card ? The manual explain's how to download & upload to a card but nothing about using the card for memory & setting up & running the wire off of this. Hijack off.

Thank's,
Harold C.



(PS) We also use the controls' pre-defined settings, the feedrates are not used in our programs.