had to setup a new pc now when i run gcode it will only run to line 500 and it stops no errors just stops
if any 1 can tell me y
tks
jj
had to setup a new pc now when i run gcode it will only run to line 500 and it stops no errors just stops
if any 1 can tell me y
tks
jj
You need a license. It's in demo mode, where the limit is 500 lines of g-code.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)