I've installed CNC Simulator and need some help to make it behave.
I run through a .nc file which I've already used to successfully engrave, but it spits an error at me "G02 Illegal Endpoint".
Is there a way to change CNC Sim from absolute to incremental arcs? This particular file was generated in absolute.
I also can't find how to set the machining stock to a round cylinder.
My X2 CNC Brain Build: http://www.cnczone.com/forums/showthread.php?t=61345
Gecko G250 wiring errors: http://www.cnczone.com/forums/showthread.php?t=68960