Can you use a G54 command in the same line as a canned cycle?
Example:
G43Z1.H1M8
G55 G82 G98 X2.536Y.155 Z-1.3 R-.95 P50 F10.
G56 G82 G98 X2.536Y.155 Z-1.3 R-.95 P50 F10.
Will this format work to drill the same hole in 2 work coordinate systems?
This is on a Fanuc 0M controller.
I'm at a new position and the existing programs seem to waste a lot of memory and space with extra lines of code
Results 1 to 2 of 2
-
02-15-2005, 03:27 AM #1
Registered
- Join Date
- Feb 2005
- Posts
- 1
Work coordinate in canned cycle line
-
02-15-2005, 04:11 AM #2
Moderator
- Join Date
- Mar 2003
- Posts
- 4826
You can always go and try it (without tools or work in place). The control will likely alarm if it does not accept it. Otherwise, just call the work coordinate system on a solitary line before each G82.
First you get good, then you get fast. Then grouchiness sets in.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With Quote
Similar Threads
-
Help teach G-code for rookie
By HighOctane in forum G-Code ProgramingReplies: 16Last Post: 03-16-2006, 04:18 PM -
Macro Work Coordinate
By firedog in forum G-Code ProgramingReplies: 7Last Post: 06-17-2005, 06:03 PM -
Haas G85 Boring Cycle (canned)
By DEAN in forum Haas MillsReplies: 7Last Post: 12-08-2003, 05:12 PM -
Tool tables
By Nimrod in forum MastercamReplies: 4Last Post: 11-24-2003, 09:31 PM -
Post configuring (black art?)
By John F in forum OneCNCReplies: 12Last Post: 07-18-2003, 07:26 PM
Posting Permissions
