[JWK42]

I got the drawings and code from a gentleman who teaches at a college in Kansas. The drawings are in Metric and say "Peter Smid CNC Programming" in one corner. I have lost his name & E-Mail address so I can't give him proper credit. But Sir, if you read this "Thank You Very Much!!"
The pieces are turned from 1" dia brass and are up to 65MM ( 2.559" )tall. I converted the code to English and ran them on our Haas SL-30. I would share the code with his permission.

[ger21]

Most likely from one of his books, and copyrighted info. I think it's in this one.

[ame="http://www.amazon.com/CNC-Programming-Handbook-Peter-Smid/dp/0831131586/ref=cm_cr_pr_product_top"]Amazon.com: CNC Programming Handbook, 2nd Edition: Peter Smid: Books[/ame]

[JWK42]

Would the G-code programs written by someone else using Peter Smid's drawings be covered under Copy Right laws. Since I don't know the author of the G-code programs I will withdraw my offer to share the G-code.
I'm making this chess set as a gift for my grandkids.

[ger21]

Depends on what the book says.