If you're familiar with material removal rates, this should raise the hair on the back of your necks... If you're not familiar with it, how does .75" Depth of Cut, 18.0" Width of Cut, at (I think it was) 22 IPM feed.. in steel sound?
See the video..
Results 1 to 2 of 2
-
02-10-2005, 09:44 PM #1
Registered
- Join Date
- Apr 2003
- Posts
- 1876
Facemilling: 300 cubic inches per minute
Matt
San Diego, Ca
___ o o o_
[l_,[_____],
l---L - □lllllll□-
( )_) ( )_)--)_)
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
02-11-2005, 05:51 AM #2
Registered
- Join Date
- Mar 2003
- Posts
- 332
I like the heat waves coming off the pile of curls. Great link.
Reply With QuoteSimilar Threads
-
Inches / Minute in Aluminum
By rcazwillis in forum MetalWork DiscussionReplies: 7Last Post: 04-07-2005, 01:15 AM
Posting Permissions
