I have some problems to adjust my laser's light way. I've tryed to focus the beam as middle of the mirrors as possible. Still, when engraving for example
some bigger photo on plywood, the results of engraving might change very much > from start everything goes nicely but in the middle of the photo it
might go very uneven and in the end the beam seems to be so strong that
it burns the picture very badly. My own opinion is that the position of the
side rails are not equal...! Have anybody had samekind problems than mine ?
I've tryed to figure this problem in my head () and I thing that once you
have adjusted those mirrors to the right position, the beam should hit always
in the same place if the rails are exactly in the same direction !
My laser is chinese made and otherwise it works very nicely ( when working
on smaller areas ). For some reason I can't reach my dealer from US, so I hope that here is somebody who could give me some advices !