i need too talk with someone about the 5 axis project
using the gear driven rotary stages with the globe motors
i am interested in investigating this as a project,
i have one rotary stage
and 3 linear stage 3 servos an aluminum fixture plate and a cast iron right angle plate 16 " tall x 9 " wide to mount the
linear stage as my z axis.
i would like too know what controller card was used and what feed rates are attainable since the
rotary stage seems too only rotate at 4 rpm. also concerned about backlash on the gears,
it seems your second project used different rotary stages.
thanks any information appreciated.
mark