587,056 active members*
3,522 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > MX3 SURFACE TO SURFACE TRIM

Thread: MX3 SURFACE TO SURFACE TRIM

Results 1 to 2 of 2
  1. 05-12-2009, 10:59 PM #1
    82rouled
    82rouled is offline Registered
    Join Date
    May 2009
    Posts
    4

    Lightbulb MX3 SURFACE TO SURFACE TRIM

    HI everybody I have a question about how to trim surface to surface ,i have a simple vertical surface and a horizontal going thru but i cant remember how to trim them thank you for your answers.
    Reply With Quote Reply With Quote
  2. 05-18-2009, 06:02 PM #2
    Steve Arteman
    Steve Arteman is offline Registered
    Join Date
    Nov 2006
    Posts
    367
    82 ROULED.
    The surfaces should intersect each other to trim both and the normals have to face each other. You can change/check normals under edit in X.
    There is a x surface training cd on the site www.cad2cam.net I don't think this specific thig is on it but there are some very useful videos to show how to create different surfaces.
    Steve Arteman
    www.cad2cam.net
    [email protected]
    www.cad2cam.net
    Programmer/ Certified Cam Instructor
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. surface
    By 1234567 in forum BobCad-Cam
    Replies: 2
    Last Post: 04-23-2009, 01:55 PM
  2. surface trim
    By encarlisle in forum UG NX
    Replies: 3
    Last Post: 03-21-2009, 08:46 AM
  3. Surface to Surface Filleting and Trimming
    By cowpoke in forum Mastercam
    Replies: 6
    Last Post: 03-17-2009, 02:42 PM
  4. cut from surface
    By Flankman in forum Musical Instrument Design and Construction
    Replies: 0
    Last Post: 09-03-2008, 12:49 AM
  5. MDT 6 Surface Cut
    By djzepp in forum Autodesk
    Replies: 0
    Last Post: 04-11-2007, 04:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules