586,129 active members*
2,789 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Gecko Drives > Estopping Mach and other drives with fault condition

Thread: Estopping Mach and other drives with fault condition

Results 1 to 3 of 3
  1. 04-23-2009, 11:50 AM #1
    jubee
    jubee is offline Member
    Join Date
    Mar 2004
    Posts
    136

    Estopping Mach and other drives with fault condition

    Hi to all out there................................out there...

    Is there a electronics diagram out there / here on the zone for a reset/err estop/Mach .... for the gecko 320.

    All Iam after is that Mach registers a fault with geckos,so the program stops,
    and the other drives stop also.

    Any help or thoughts would be good.....Thanks?

    Regards
    JUbee
    Reply With Quote Reply With Quote
  2. 04-23-2009, 08:35 PM #2
    Runner4404spd
    Runner4404spd is offline Registered
    Join Date
    Jun 2005
    Posts
    1015
    i think this needs to be wired to the e-stop switch as well. ultimately though i am looking for the same info as the OP.

    thanks
    Reply With Quote Reply With Quote
  3. 04-23-2009, 09:03 PM #3
    Al_The_Man's Avatar
    Al_The_Man
    Al_The_Man is offline Community Moderator
    Join Date
    Dec 2003
    Posts
    24221
    Did you check this out?
    http://www.sfu.ca/~alan/gecko/err.html
    Little bit cumbersome to have to go to this, but it may be an answer.
    Al.
    CNC, Mechatronics Integration and Custom Machine Design

    “Logic will get you from A to B. Imagination will take you everywhere.”
    Albert E.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. conversion of anilam drives with mach 3 software
    By ptpz in forum Machines running Mach Software
    Replies: 11
    Last Post: 03-15-2011, 07:48 PM
  2. 201 drives fault over and over
    By wes in forum Gecko Drives
    Replies: 4
    Last Post: 07-03-2008, 06:06 PM
  3. how do i get mach to halt for a servo fault
    By fast89 in forum Mach Wizards, Macros, & Addons
    Replies: 1
    Last Post: 04-08-2008, 08:10 AM
  4. Will my Hurco KM-1 maintain speed with step/dir drives and Mach 3...?
    By DaSnake in forum HURCO
    Replies: 2
    Last Post: 07-28-2007, 11:17 AM
  5. Is Mach 3 able to control 3 independent gecko drives?
    By mrmz in forum Mach Software (ArtSoft software)
    Replies: 1
    Last Post: 07-27-2007, 11:13 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules