Does anyone know where I could find a 5/32 end mill holder for an R8 taper machine? I would like to use one for predrilling 10-32 tapped) holes in some aluminum. Due to the tool changes I will be doing, I would like to try the endmill holders to help preset the length of the tools.
Thanks
Dan
Thread: 5/32 endmill holder
Results 1 to 3 of 3
-
04-21-2009, 02:20 AM #1
Wanna be
- Join Date
- Mar 2004
- Posts
- 636
5/32 endmill holder
Check out what I am working on at www.routerbitz.com!
-
04-21-2009, 07:32 AM #2
Registered
- Join Date
- Feb 2007
- Posts
- 1084
ER11 collet holders is probably the best your going to do. Unless you get a 1/8" EM holder and bore it open.
MC
-
06-01-2009, 12:24 PM #3
Registered
- Join Date
- Mar 2008
- Posts
- 443
An R-8 collet in 5/32" size is not at all uncommon. You should be able to buy one from just about any industrial supply house. Fair warning though, if you're using a carbide end mill, you'd better get a high-quality collet, such as a Hardinge, to assure minimal runout.
Reply With QuoteSimilar Threads
-
Router Bit or Endmill
By cncneo1 in forum WoodWorking TopicsReplies: 14Last Post: 11-27-2017, 03:00 PM -
1/8" shank endmill holder
By CNCMike in forum MetalWork DiscussionReplies: 7Last Post: 10-24-2008, 04:58 AM -
No Endmill Holder
By DroopyPawn in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 11-21-2007, 04:14 AM -
Endmill bit and holder.
By ihkim in forum MetalWork DiscussionReplies: 0Last Post: 07-26-2005, 07:38 PM -
Endmill runout
By dberndt in forum MetalWork DiscussionReplies: 14Last Post: 01-28-2005, 06:26 AM
Posting Permissions
