[BetaBob]

Hi,
I've been reading this forum for years and have always found the answer I was looking for without asking a whole lot of question. But I can't find the answer to this one.

I just purchased a couple Bridgeport VMC 1000/22 and didn't get any tooling with them. I have purchased some BT40 holders but do not know which style pull studs to get.

Can someone give me a part number so I can get these things up and running?

Thank You
BB

[machintek]

You need Bridgeport service bulletin 206 which gives dimensions of the BT40 pull studs. It is 1.25MB in size so I need a email address.

George

[BetaBob]

[email protected]

Thank You

[boolay]

Any chance of getting a copy of this service bulletin? [email protected]

Or does anyone now the size/spec of pull studs for a VMC1000/22

[jthornton]

A call or an email to Maritool and you should have your answer. I tooled up my BP from there and they have some real quality made in America tool holders for a fair price and no I don't get a kickback or work for them...

John

[BetaBob]

boolay. Bulletin is coming to you in your email.

[nlh]

I apologize for pulling up such an old thread, but was wondering if this bulletin was still available? I would appreciate a copy if possible.

Thanks

[BetaBob]

Here ya go

I apologize for pulling up such an old thread, but was wondering if this bulletin was still available? I would appreciate a copy if possible.

Thanks

[nlh]

Thanks BetaBob!