586,693 active members*
2,988 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Stepper Motors / Drives > Alexander's PIC 3 Axis Board (Not Working)

Thread: Alexander's PIC 3 Axis Board (Not Working)

Results 1 to 3 of 3
  1. 03-28-2009, 06:12 PM #1
    Telly
    Telly is offline Registered
    Join Date
    Aug 2008
    Posts
    25

    Exclamation Alexander's PIC 3 Axis Board (Not Working)

    I have made myself the pic 3 axis board and current limiter to go with it.

    But I cannot get my motor to run. This is the wiring i am using.

    http://img19.imageshack.us/img19/6826/29240594.png

    I am running the test on the Z axis only at the moment.

    When In Mach3 I press my direction arrow I only see a 250mv been produced at the pin out of the Pic.

    Have I done something incorrect? I'm using RIF620 on the driver board.

    Any ideas?

    Thank You!

    Telly
    Reply With Quote Reply With Quote
  2. 03-28-2009, 07:41 PM #2
    jam5295
    jam5295 is offline Registered
    Join Date
    Mar 2008
    Posts
    11
    Try contacting Phil at http://PMinMO.com, he is very helpfull.
    Reply With Quote Reply With Quote
  3. 03-29-2009, 11:01 AM #3
    Telly
    Telly is offline Registered
    Join Date
    Aug 2008
    Posts
    25
    Moved to : http://pminmo.com/phpBB2/viewtopic.php?f=27&t=415
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Taig X axis not working
    By soildruper in forum Taig Mills / Lathes
    Replies: 3
    Last Post: 06-01-2008, 11:02 PM
  2. Can I hook up a 3-axis board to a 1-axis board ?
    By Redline in forum Xylotex
    Replies: 7
    Last Post: 02-10-2007, 04:45 AM
  3. Fanuc Z axis not working
    By Derek.C in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 5
    Last Post: 12-05-2006, 11:47 PM
  4. New 5 axis screen set I've been working on
    By Darc in forum Screen Layouts, Post Processors & Misc
    Replies: 14
    Last Post: 04-10-2006, 08:38 PM
  5. 2 amp camtronics board working
    By gearcut in forum Stepper Motors / Drives
    Replies: 0
    Last Post: 05-11-2005, 04:40 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules