There's a trick here. SW used to make it very obvious but in later versions it's more 'obscure'. If you go to tools/options/ and then the 'Document Properties" tab. Select "units" on left side. In there you can select the lowest fraction Demoninator you want to use. Over to the right of that there is a "More" Column. If you click there it will give you a couple options. One is the rounding feature you are seeking.
Save and your done. Also as was mentioned it's helpful to create your own templates for drawings as well as models.
This is all for SW08 btw [I've gotta load 09 one of these days now that Sp2.0 is out]
Hth
J
JerryFlyGuy
The more I know... the more I realize I don't
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)