[tubeguy]

Hello all: Long time lurker first time poster.

Have bought my first cnc mill (bed type single tool) from a on floor auction and need to move it. I tried today to move the head down to align up the counter weight hole and couldnt get it to move. I fooled around with the anilam 3300MK controls to try and get in manual mode but never got there. After boot up and on the home page I get the message "servos off line".

Could any one possibly give me the sequence step by step to get it into manual mode and lower the head?

Once back at home base Ill have plenty of time to learn it.

BTW if anyone has tube or tube mfg/bending/spinning/louver/perf questions Im your guy!

[Toolbit]

after the message "servos offline"

twist and pull out the red "emergency stop button" to reset

then push the reset button "softkey" should be labled reset

[Larry Patterson]

I am looking for a Anilam 3300 Mk control system for parts. Any help would be appreciated. Please call Larry at 801 216 4576. Thank you