[gjenkins]

Hello, our Cincinnati Milacron Talon with an 850sx control has a twelve position turret. I can't get the machine to index to the number twelve position? I' ve tried through the programming (T12 M6 or M26) and through M.D.I. (T12 M6) the machine gives an alarm "INVALID TOOL POSITION" All other positions work fine. Can anyone tell me if this is related to a parameter, if so which one? Or any suggestions????

[advt001]

This has happened to me on a Sabre 1000.After I made sure it wasn't set to manual load, I rotated the carousel thru 2 complete revolutions.Dont ask me why cause I dont know but it did work.

[Avenger5]

Check the Tool Setup, you may not have a tool defined for that turret position. You should be able to setup as many as 99 different tools but they all need to know what turret postion they are in. Look on the Tool Setup screen clear to the left in the first column; that's where you define the position.