HI EVERYBODY!!!
I have 3 mashine tools -EGAR320,Egar 320Ò and glass table with NUM 1040(also Z.Bavellony)
PROBLEM with EGAR320:
after reprogramming EGAR320 I have a mistake at a capture of the tool a spindle approximately in 1-2 degrees.The Tool is incorrectly established in a spindle.
HOW to solve this trouble (with software îr Hardware)?
For reprograming i am use NUMTOOLS WORKSHOP and files beckap my EGAR 320 from Bavellony
Best regards !
Russia
Sochi
PUTEVI
Burula Oleg(lead.eng)
[email protected]