[mmachining]

I am trying to run this program on my Hurco KMB1. I keep getting a error bad arc. It stops at N30, I think its because the I,J, are on a line by them selves. Is there a way to change this setting? I do not have them setup this way to put on seperate line. Heres some of the code.
%
N2G00
N4G90
N6G70
N8M25
N10T01M06
N12M25
N14S2250 M3
N16 Z0.1000
N18 X5.7625 Y0.8000
N20 G00 Z-0.6000
N22 G01 Z-0.7000F10.
N24 G03 X6.3125 Y0.2500 I6.3125 J0.8000 F20.
N26 G01 X7.6251
N28 G02 X8.0000 Y-0.1153 I7.6251 J-0.1250
N30 G03 I8.0100 J-0.1150
N32 G01 X8.9900
N34 G03 I8.9900 J-0.1150
N36 G02 X9.3749 Y0.2500 I9.3749 J-0.1250
N38 G01 X12.0001
N40 G02 X12.3750 Y-0.1153 I12.0001 J-0.1250

[JWC]

I have the same problem on one of my Max2 machines running v7.24. You need to include the x-y's (from previous line) when you cut a radius. It works for my v8.51 though....
What cad/cam are you running?

[mmachining]

Bobcad ver.21. Thanks I thought that might be it. Fussy little thing aren't they!