Is there a way in mastercam to take a manually programmed program,and load into mastercam with the correct stock options and run backplot or verify?
Is there a way in mastercam to take a manually programmed program,and load into mastercam with the correct stock options and run backplot or verify?
Sorry mastercam does not read gcode you need a few of the certain NC editors like Predator editor that will do that or a a full verification software.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
Predator Virtual CNC is great for checking manually written G-Code programs along with NC-Plot.
I use both of these to check, verify, and edit programs. However Predator Editor has some great editing tools I'm not too thrilled with it's Back Plotting capabilities or options. So NC-Plot takes it's place.
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
THANKS
Your welcome! Glad to be of help:rainfro:
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com