Anybody else running one of these controllers? I have 2 here, one of which likes to decide for me whether or not my arc centers in my posted programs are "logical" or not and change them on me if it doesn't think the arc center is logical. I've screwed around with the setup to no avail...I did find the Maximum Arc Correction setting, but this seems to set the tolorence for how often the "Warning Arc adjusted beyond maximum ...." error messege comes up and not the actual maximum amount to correct. I've also screwed around with limiting my maximum and minimum arc radii posted to my programs, also to no avail. It seems this Anilam has a mind of it's own when it comes to "logical arc centers" .I would like to turn this arc "correction" off completely since it's "corrections" arent really corrections at all, they gouge my parts, but I can't seem to be able to find where I might do this in either the operator or builder steup of the controller.

Also, this seems to happen more frequently on 180-360 degree arcs ......

What I find most odd is that the other Anilam 3300MK we have does not this.