Hi. I own a Hurco KM-3P Three Axis Milling Machine. The machine worked fine for aprox. 1 year, but today, it suddently stopped working. I constantly get the error messages: "FAILED AXIS CONTROLLER ON X", "FAILED AXIS CONTROLLER ON Y", or "FAILED AXIS CONTROLLER ON Z" and sometimes "MOTION ERROR DETECTED ON Z". Sometimes, if i turn off the machine and then turn it back on, it works for a few seconds or minutes, i can calibrate it, and even run a program, but suddently, it stops and shows one of the messages mentioned above. From time to time the error message dissapears after less than a second, and the machine doesn't stop, but sometimes the message wont dissapear and the machine stops. I'm thinking maybe it's the control cards fault, but i'm not sure. Does anyone have other ideas that could help? Thanks.