Ok I have a g320 running an 850oz servo with a ballscrew, I am also using the sound logic encoder interface, everything is shielded wiring.
In mach 3 i'm running a peck cyccle and checking the encoder readout on the settings screen, this is what i'm getting as the bottom stop anyone have any ideas?
A total z change in 0.0262" over 7 holes, using a 200 cpr encoder for a final count of 4063.99994, i find 0.026" a bit excessive
.5887
.5901
.5847
.5768
.5739
.5704
.5625
Chris