I've followed the wiki for the simple method and I can't get it to work.
http://wiki.linuxcnc.org/cgi-bin/emc...Remote_Pendant
Could someone help me? I can email my .hal files and the error file that EMC puts out.
Thanks,
Mike
[email protected]
I've followed the wiki for the simple method and I can't get it to work.
http://wiki.linuxcnc.org/cgi-bin/emc...Remote_Pendant
Could someone help me? I can email my .hal files and the error file that EMC puts out.
Thanks,
Mike
[email protected]
Mike,
Quick question what version of Unbuntu are you running. I did the example in 6.06...
John
It's the latest live CD I think its Ubuntu 8.04
I see this is an old thread, but did you gt it working? I followed the same directions, and after much cussing and head scratching managed to get it working a few days ago.
I am happy to let you know what I did if required.
I am in no way an expert and may have done it wrong but it works.
Regards,
Jayson
Quick... catch all the smoke so I can stuff it back in.
Jason,
What did you have to do to get it to work? I need to check what you did against the wiki site to make sure it is correct.
Thanks
John
Hi John,
I will take a look tomorrow and let you know the changes I made,however I see you have already updated the wiki so you may have found what was missing, but I'll still check.
Thanks for the original information, it will make a great addition to my machines.
Regards,
Jayson
Quick... catch all the smoke so I can stuff it back in.