Hi sorry to start a thread like this
I was just making sure that this will work before I order, as I allways have bad luck when buying things like this =
This = HobbyCNC EZ Driver Board Kit
http://www.hobbycnc.com/products/hob...ver-board-kit/
with 3 x NEMA 23 1-Amp Unipolar Stepper Motor
using the Daisy chaining computer PSU idea of 3 psu's
http://www.cnczone.com/forums/showthread.php?t=17548
The psu's I have allready as I have 100's of computer stuff, but might not use that idea yet I just thought I would ask aswell.
This is for a router / engraver table I want to build its going to be no more than 12" x 12" for the table.
any thoughts?
as I am trying to keep cost low but have a nice machine.