I recently bought a milltronics lathe with a cent V controller. It has the capability of being programmed in g code or conversationally. I have stumbled my way through a couple of programs conversationally by looking at the one example I could find in the manual and then doing a lot of guessing. But I am far from happy with my progress. I am wondering if anyone here would be willing to help me out a bit. Say for example, give me a step by step if I included some simple part drawing. Any help would be much appreciated. By the way, I am fairly familiar with programming knee mills and I regularly use a TRAK lathe at my other job so I am not totally in the dark but I think a little help would go a long way here.

Thanks,

Joe