[MJR]

Hi to all:

I am new to this forum. I have a home-built cnc router but need to add an additional machine to cnc cut aluminum & steel. I do not have the time to find an older manual mill & convert to cnc. I have been looking at the Tormach & the Industrial Hobbies machines. I would appreciate any suggestions or comments about these two machines or any others I may have over-looked. Looking for something larger than a desktop but smaller that a full-sized floor mill.
I would prefer a machine to run using Mach3. I mostly use V-Carve Pro and some Artcam stuff.
Thanks to all in advance.

Rusty

[leafft]

i am also new here, i am in the line of laser engraving and cutting machine, if any body need help can contact [email protected].