Hi all,
I am stumped and looking for help. Using VisualMill basic out of Rhino, which looks just like VisualMill stand alone with a few less options.
In my MOPs regardless of how I set up my F and S (and regardless of my tool and RPM selections) my G Code shows a feedrate of 20. I have a Digital Tool 5'x10' gantry table with a homemade control (geckos and servos) with a 1.5 horse Porter Cable router as a spindle. I am wanting to cut profiles out of MDF. Pretty simple stuff and I think my feeds can be better than 20.
There is an option to load feeds and speeds and some vague instructions on how to set up your own parameters, but I don't know where to start.
Any assistance greatly appreciated!!!!
THANKS!!!!!