Hi, I'm trying to determine which post processor I need for my plasma table. I'm using sheetcam, great product by the way. Following is a copy and paste of a simple NC file that I know works.
G70
G91
G00X2.500Y46.750
G41M15
F110.0
G01X0.000Y-0.500
G01X0.000Y-45.750
G01X-2.000Y0.000
G01X0.000Y45.750
G01X2.000Y0.000
G01X0.250Y0.000
M16G40
G00X2.500Y0.500
G41M15
G01X0.000Y-0.500
G01X0.000Y-45.750
G01X-2.000Y0.000
G01X0.000Y45.750
G01X2.000Y0.000
G01X0.250Y0.000
M16G40
G00X-5.500Y241.750
M00
G00X
The table has the following specs.
Koike - D7 Cutting Tips
Coordinate Drive Control System
Type: LYNX
System: 6D55181G04
Control/Amplifier: 6D55179G03
Thanks,
Tim
Results 1 to 2 of 2
-
01-23-2008, 12:28 PM #1
Registered
- Join Date
- Jan 2008
- Posts
- 4
Can anyone help with sheetcam post processor?
-
01-25-2008, 09:02 PM #2
Gold Member
- Join Date
- Jul 2005
- Posts
- 2415
Post this in the SheetCAM section on the zone or on SheetCAM's Yahoo Forum. The author monitors both and can give you assistance. Since there are no Z moves the THC is stand-alone and there are special M codes that are specific to your controller.
Reply With Quote
Posting Permissions
