[guhl]

Does anybody have the information about types of master PCB's on 10T? For example, there is A16B-1010-0041/04A on my control and I want to replace it. I've found A16B-1010-0040/04C on the internet. But there are some differences (saw the foto): optical plugs are absented and there are 3 processors instead of 2 on my PCB. If I replace the plugs, take out processor and replace ROMs from my PCB, will it operate?

[mroy0404]

I would replace with the same part #, this will ensure proper operation.

[cncdiag]

Are you using the optical plugs ?

[GPena]

You can use 0040 replacing 0041 with no problem, you just have to fit the board with the jumpers and add the IC's in your original board.

GP.

[guhl]

Are you using the optical plugs ?

Plugs are used for connection with interface module IF01A and with CRT unit.
Regards

[guhl]

You can use 0040 replacing 0041 with no problem, you just have to fit the board with the jumpers and add the IC's in your original board.

GP.

Are all the settings explained in manual?
Regards

[cncdiag]

If you are using the optical plugs on your 0041 board. The 0040 board is not interchangeable because it does not have the optical plugs.

[guhl]

If you are using the optical plugs on your 0041 board. The 0040 board is not interchangeable because it does not have the optical plugs.

I want take the plugs out from 0041 and set them on the 0040. Are there any special ICs wich provide the optical interface? If yes, and I transpose them, will the system operate?