Dear All,
can any one help me to solve that alarm 408 servo alarm "serial not RDY", i think the serial spindle parameters no correct, i need the motor code for the spindle motor model αP18, i'm not sure if it is right.
regards,
Sting
Dear All,
can any one help me to solve that alarm 408 servo alarm "serial not RDY", i think the serial spindle parameters no correct, i need the motor code for the spindle motor model αP18, i'm not sure if it is right.
regards,
Sting
I have the same problem :-(
did you find any solution?
would be great to hear from you
really?
I have the same situation.
the Operator`s Manual says...
408 SPINDLE SERIAL LINK START FAULT
This alarm is generated when the spindle control unit is not ready for starting correctly when the power is turned on in the system whit the serial spindle
The four reasons can be considered as follows:
1) An improperly connected optic cable, or the spindle control unit`s power is off.
2)when the NC power was turned on under alarm conditions other than SU-01 or AL-24 wich aare shown on the LED display of the spindle control unit.
3)Other reasos (improper combination of hardware) This alarm does not occur after the system including the spindle control unit is activated.