I have a Fanuc OM-A & B models it's ladder got lost, I don't have it's EPROM's. I would like to load the new ladder in these systems. Earlier I had loaded the ladder in Fanuc OM-C & D models using RS232 port & I am not familiar with Fanuc OM-A & B models. Can somebody help me & tell me the parameter number for PMC loading menu display as earlier I had used in Model OM-C & D. ( Parameter #71 bit #6 ) Can I use Parameter # 71 bit #6 same way as I had used in model OM-C & D? I would appreciate for sending me manuals for Fanuc OM-A & B model specially connection manual hardware & maintenance.
Results 1 to 2 of 2
-
11-21-2007, 07:29 AM #1
Registered
- Join Date
- Feb 2006
- Posts
- 213
Fanuc OM-A or OM-B system PMC problem.
-
11-22-2007, 02:55 PM #2
Registered
- Join Date
- Feb 2006
- Posts
- 213
hi
still awaiting somebody's help, please help me!!!!!!!!!!
Reply With QuoteSimilar Threads
-
Fanuc 5T System BTR
By protyper in forum CNC (Mill / Lathe) Control Software (NC)Replies: 6Last Post: 11-08-2007, 03:06 PM -
Fanuc System
By chinthakahk in forum FanucReplies: 2Last Post: 10-01-2007, 09:50 AM -
Servo system tuning problem??
By REVCAM_Bob in forum Community Club HouseReplies: 2Last Post: 12-17-2006, 02:20 PM -
Dynapath System 10 keypad problem?
By Dick L. in forum DNC Problems and SolutionsReplies: 0Last Post: 11-23-2006, 03:26 AM -
Fanuc system 10
By kayleesdad in forum CNC (Mill / Lathe) Control Software (NC)Replies: 17Last Post: 01-30-2006, 05:59 PM
Posting Permissions
