Hello, is there someone who could help me here? Could we add this cycle to machine or we have to manually set up center of rotating for 5 axis?
Hello, is there someone who could help me here? Could we add this cycle to machine or we have to manually set up center of rotating for 5 axis?
If you have the options on the m/c
Then the probe cycles should be accessible via the function buttons
We have DMU65 with iTNC 530 (Heidenhain)
In edit mode, go... CYCL DEF.... page right...DECKEL MAHO #... , This should put you in the correct callup area of probe cycles to set kinematics
Note... set ruby probe true 1st, then calibrate length and probe, then do kinematic
If you have manuals or machine's CDs, ... see the "cycles manual".